[TG] [TG11] Navionics chart data shared?
|
05-13-20, 11:27 AM
(This post was last modified: 05-14-20 11:57 PM by Tom - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[TG11] Navionics chart data shared?
I have a C95 (master) and C125 networked as shown in the attached pictures. I have purchased a new Navionics Platinum+ card to update the charts.
Please advise if I will need to actually purchase two Navionics Platinum+ cards, one for each MFD, or is there a way to share the chart data between the two MFD's? I found the following info. on the forum but am not clear if it applies seeing I seem to have the C125 on the HS network. https://forum.raymarine.com/showthread.p...+RAYFAQ%23 Thanks, Tony |
|||
05-15-20, 12:00 AM
Post: #2
|
|||
|
|||
RE: [TG11] Navionics chart data shared?
Hello Tony,
Yes, chart data should automatically be shared through the Raynet/SeatalkHS network. It doesn't matter which display or which slot the card is in, it should be available on both. The only thing which is available only on the display where the card is is the SonarCharts Live personal contour mapping. Regards, Tom Raymarine since 1999. Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras Location: Sydney, Australia. Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)