Raymarine forum / Raymarine Forums / Instruments v / What is maximum mounting surface thickness for i40 Depth Display?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What is maximum mounting surface thickness for i40 Depth Display?
06-14-17, 04:20 PM
Post: #1
JimG
Unregistered
 		 
What is maximum mounting surface thickness for i40 Depth Display?
Can you please tell us the maximum thickness of the mounting surface for an i40 Depth Display? I cannot find this in the documentation.
Quote this message in a reply
06-15-17, 10:34 AM
Post: #2
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: What is maximum mounting surface thickness for i40 Depth Display?
Welcome to the Raymarine Forum Jim,

Using the supplied threaded rod, the maximum mounting surface thickness which may be accommodated by an i40 instrument is approximately 1.3". However, should the supplied brass threaded rod be replaced with longer threaded rod, then the limit of the mounting surface's thickness would only be limited by the length of the threaded rod used.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication