Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Clutter but no targets
01-14-18, 11:00 PM
Post: #1
Clutter but no targets
Hello
I am helping a friend with his ST 600 hsb2 display. Right now the concern is radar. We get clutter only at the dock and no signal or targets.
Find all posts by this user
Quote this message in a reply
01-15-18, 11:41 AM
Post: #2
RE: Clutter but no targets
Hi olegreg,

Could you please provide the model of display and radar you are using? This will ensure a more accurate answer.

- Dave
Find all posts by this user
Quote this message in a reply
01-15-18, 12:03 PM
Post: #3
RE: Clutter but no targets
Radar M92650
MSG RL70C
Greg
Find all posts by this user
Quote this message in a reply
01-15-18, 12:06 PM (This post was last modified: 01-15-18 12:19 PM by Dave - Raymarine - Moderator.)
Post: #4
RE: Clutter but no targets
Also,
If we think that the scanner might be the issue, can we send back just the circuit board? Or do we send the whole radome?
Greg
Find all posts by this user
Quote this message in a reply
01-15-18, 12:22 PM
Post: #5
RE: Clutter but no targets
Hi Greg,

Thank you for your response.

From the information you have provided, I believe the problem resides within the dome. The entire dome should be sent into the service department for evaluation, and you can fill out an out of warranty repair request Here.

- Dave
Find all posts by this user
Quote this message in a reply
01-15-18, 01:07 PM (This post was last modified: 01-15-18 03:20 PM by Dave - Raymarine - Moderator.)
Post: #6
RE: Clutter but no targets
Another thing Dave,
This morning in North Idaho it's 30 degrees. No GPS fix. External antenna. Tried
Cold Start. We had GPS last night. Too cold?
Find all posts by this user
Quote this message in a reply
01-15-18, 03:32 PM
Post: #7
RE: Clutter but no targets
Hi Greg,

Thirty degrees Fahrenheit should not be too cold for the GPS antenna to operate. However, the cold may effect its performance if an old battery is inside.

- Dave
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)