Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] AIS displayed on Axiom from Icom VHF?
01-03-20, 08:50 PM (This post was last modified: 01-06-20 11:27 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] AIS displayed on Axiom from Icom VHF?
I’m looking at getting the Icom 506 vhf with NMEA 2000 and AIS. My understanding is that the ais target info will be displayed onto my axiom over the cart display and also radar display, is this correct? Thank you
Find all posts by this user
Quote this message in a reply
01-06-20, 11:32 AM (This post was last modified: 01-06-20 11:33 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] AIS displayed on Axiom from Icom VHF?
Welcome back to the Raymarine Forum SE-FL,

Displaying AIS targets within an Axiom MFD's Chart application requires that the MFD (or interfaced GPS sensor) have acquired a GPS position FIX and that it be properly interfaced to a AIS receiver/transceiver having a NMEA 0183 or NMEA 2000 communications interface. In addition to the items listed above, displaying AIS targets with the Radar application would require that the MFD be interfaced to a source of heading data (ex. Evolution autopilot, AR200 Augmented Reality Sensor, etc.).
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)