Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
C120 and DSM 30 software downloads
07-07-16, 04:26 PM
Post: #1
C120 and DSM 30 software downloads
OK so this is the situation; I have a C120 MFD that I have recently downloaded the v5.16 operating system into.(seems to work fine). I noticed there is also an upgrade to the DSM-30 operating system v4.20 and v518 bootloader. This download consists of : DSM300-V518-C, DSM300-V4-20, and a autorun file that I have copied to a flash disk. According to a previous post, I have also installed autorun 00 sh sig and autorun 00 sh on the same flash card.
Should I attempt to download this into my system? I have read somewhere that I may have to power down the DSM30 during this process. I don’t have control to do that, it is installed in behind my MFD in the dash counsel of the boat.
1. Should I delete the original autorun file on the card?.
2. Should I just leave well enough alone and not try to download it?
One other question; My transducer is a Airmar 31-092-7-01 (E66014) Should I be getting water temperature from it? I’m not now.
Find all posts by this user
Quote this message in a reply
07-08-16, 02:17 PM
Post: #2
RE: C120 and DSM 30 software downloads
Welcome to the Raymarine Forum Hydra Sport 25,

The subject software update is not applicable to DSM30/300 Sounder Modules which have been interfaced to C-Series Classic MFDs. Do not update the software of your DSM.

The B117 Transducer is designed to support depth alone. Raymarine offers the E66071 (Plastic) and E66072 (Bronze) ST800 / P120 Speed/Temperature Transducers to add speed and temperature data to a system such as yours. These transducers feature a Y-Cable to permit them to be installed between the DSM and the B117's plug.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)