Target (fish) depth numbers

[semnet]

I have a e97 and in the user manual it shows the depth of some of the fish. I know how to set the fish alarm and sensitivity but how do I set up the display to show the depth on the larger fish that exceed the alarm depth?

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Semnet,

It is recommended that the Fish Shallow Alarm Limit be set to the desired value and that the Fish Deep Alarm Limit be set to the maximum depth to the maximum depth of the water being fished. The Fish Alarm Sensitivity should then be increased until it is alarming (and therefore mark) the fish at the deeper depths.