Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MN100-2 gauge not reading consistently
07-14-17, 10:42 AM
Post: #1
MN100-2 gauge not reading consistently
I have a Tacktick depth sounder T905 wired into a hull transmitter. I sent the unit back for testing and it was verified to be working correctly. When I switch the unit on, sometimes it shows 3 dashes, and then sometimes it shows the depth. The depth will show for a minute or so, then it goes back to 3 dashes, then it will show depth again. Can anyone tell me what is going on and why it wont show depth consistently?
Find all posts by this user
Quote this message in a reply
07-25-17, 03:50 PM
Post: #2
RE: MN100-2 gauge not reading consistently
Welcome to the Raymarine Forum southerncross,

Please excuse this late response to your thread. Based upon the symptoms reported and actions taken, it appears that the transducer is failing. This may be verified by testing the hull transmitter with another transducer which has temporarily suspended over the side of the hull. When performing such testing, the depth of the water must be at least 3' beneath the transducer.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)