Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
E80 MFD compatibility with SmartPilot S1 and ST6001
07-21-17, 08:01 AM
Post: #1
E80 MFD compatibility with SmartPilot S1 and ST6001
I've got a SmartPilot S1 and ST6001 on SeaTalk with an E80 MFD. The MFD is getting Heading data from the pilot, but the MFD status box shows a coloured pilot wheel and an "X", and the pilot control menu item is not present on the E80. The pilot is operating normally. I am wondering if there is a compatibility problem between the pilot and MFD, or if a software update is needed on the pilot.

Is the E80 MFD with software App v5.69 and Boot code v1.03 compatible with a SmartPilot S1 course computer software v S1 463 and Controller ST6001 with software v15?

Thank you,
Don
Find all posts by this user
Quote this message in a reply
07-25-17, 08:31 AM
Post: #2
RE: E80 MFD compatibility with SmartPilot S1 and ST6001
Welcome to the Raymarine Forum Don,

Please click here to view a FAQ addressing this subject. Within E-Series Classic MFDs operating with v5.69 software, the command sequence MENU->SYSTEM SETUP->SYSTEM INTEGRATION->AUTOPILOT CONTROL is used to configure the Autopilot Control feature's state. The S1/S1G/S2/S2G/S3/S3G Autopilot Course Computers will support the MFD's Autopilot Control feature when items within the referenced FAQ have been satisfied.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)