Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Inverted mount for Fair Camera
03-22-18, 02:35 PM (This post was last modified: 03-23-18 08:02 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Inverted mount for Fair Camera
Our new FLIR camera is being mounted up on the mast on a Scanstrut mount. It is in the inverted position but the mount above it would seem to expose the wiring connections to rain and pooling water since the mount is an open framework. Does it need to have protection for this to seal the top from water ingress?

Thanks,

Paul Shard
Find all posts by this user
Quote this message in a reply
03-23-18, 08:00 AM (This post was last modified: 03-23-18 08:01 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] Inverted mount for Fair Camera
Welcome to the Raymarine Forum Paul,

Mounting the camera ball down within a ScanStrut mount would not be considered a best practice for the potential problems which you have identified. Additionally, the ClearCruise feature, introduced in MFDs running LightHouse 3 v3.3.170 and later software, is not supported in conjunction with M132 and M232 thermal cameras which have been installed in the ball down orientation.
Find all posts by this user
Quote this message in a reply
03-28-18, 08:16 AM (This post was last modified: 03-28-18 08:56 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: [CA] Inverted mount for Fair Camera
Thanks very much Chuck - we'll remount the camera right side up!

Paul
Find all posts by this user
Quote this message in a reply
03-28-18, 08:56 AM
Post: #4
RE: [CA] Inverted mount for Fair Camera
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)