Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] VesselView
04-12-18, 08:57 AM (This post was last modified: 04-12-18 10:47 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] VesselView
Is axiom 7 compatible with VesselView. If not will it be in the future.
Find all posts by this user
Quote this message in a reply
04-12-18, 10:28 AM (This post was last modified: 04-12-18 10:47 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA] VesselView
Welcome to the Raymarine Forum Joe,

Many bridge engine data from VesselView systems to NMEA 2000 systems using Mercury Marine's SmartCraft to NMEA 2000 Engine Gateway. It is recommended that you check with the engine manufacturer to verify whether this engine gateway may be used with your VesselView engine system. Please click here to view a FAQ addressing this subject.
Find all posts by this user
Quote this message in a reply
04-13-18, 06:07 PM
Post: #3
RE: [CA] VesselView
I am also planning to install a Mercury Smartcraft to NMEA 2000 Engine Gateway on my boat. But I am not sure which Raymarine spur cable I should order to mate the Gateway to the boat's Seatalk NG network.
Find all posts by this user
Quote this message in a reply
04-16-18, 08:29 AM
Post: #4
RE: [CA] VesselView
Joe,

The SmartCraft to NMEA 2000 Engine Gateway is terminated with a DeviceNet (M) Micro-C socket. Please click here to view a FAQ addressing your latest question.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)