Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Seatalk set up
04-06-16, 04:41 PM
Post: #1
Seatalk set up
The system

newest digital radar
autopilot pump and actuater switch av 100
gps
fishfinder
monitor c series

It came as part kit Included ev1 backbone kit
I installed the spur adapter with split wires to av100
does this power the backbone?? The book says no?
I also hooked up the red /black spur power wire to backbone. Is this redundant?
Thanks for your help
aloha
Find all posts by this user
Quote this message in a reply
04-06-16, 06:20 PM
Post: #2
RE: Seatalk set up
Welcome to the Raymarine Forum Dan,

Unlike the ACU200 and ACU400, the ACU100 is not designed to supply power to a SeaTalkng backbone. As such, the SeaTalkng Power Cable must be installed and connected to a switched 12VDC power circuit and protected with a 5A fuse/breaker.
Find all posts by this user
Quote this message in a reply
04-06-16, 06:56 PM (This post was last modified: 04-07-16 09:27 AM by Chuck - Raymarine - Moderator.)
Post: #3
RE: Seatalk set up
Thanks Chuck,
You guys (and ladies) are sure very helpful and we appreciate you.
Why does it have a split 5 wire to spur cable plug in than?on the acu 100?
aloha
Dan
Find all posts by this user
Quote this message in a reply
04-07-16, 08:16 AM (This post was last modified: 04-07-16 08:16 AM by Steve - Raymarine - Moderator.)
Post: #4
RE: Seatalk set up
The reason for the split Seatalk NG spur cable is the ACU-100 has a bare wire terminal strip installation for the Seatalk NG port. The terminal strip is color coded.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)