Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] 1Kw transducer direct on Axiom
09-26-18, 08:25 AM (This post was last modified: 09-26-18 02:06 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] 1Kw transducer direct on Axiom
Thinking to buy the Axiom DV or RV with CP370 and 1Kw transducer but don't have the budget to buy all at the same time.
Need to catch more fish to have the complete system with the CP370 and the DV/RV transducers.
Can I buy the Axiom DV or RV and for now, only the 1Kw transducer to give me depth. How deep will this go?
Find all posts by this user
Quote this message in a reply
09-26-18, 02:14 PM
Post: #2
RE: [CA11] 1Kw transducer direct on Axiom
Welcome to the Raymarine Forum Rene,

It is certainly possible to create your system in stages. In this case, it would be recommended that you consider purchasing the 1kW CP370 compatible transducer which you ultimately plan to use and then adapt it for use with either the Axiom DV or Axiom RV MFD to be purchased. These MFDs will support driving the adapted 1kW 50kHz/200khz transducer with 600W of power. This should permit sounding in depths approaching 1000' (50kHz). As budget permits, the DV or RV transducer and CP370 may be added to the system. A the point which the CP370 is added to the system, the 1kW CP370 compatible transducer may be disconnected from the MFD and will instead be interfaced directly to the CP370. The CP370 would be interfaced to the MFD via an appropriate length of RayNet (F) to RayNet (F) Cable.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)