Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] AP Selection
02-27-19, 03:56 AM (This post was last modified: 02-27-19 07:42 AM by Louise - Raymarine - Moderator.)
Post: #1
[CA11] AP Selection
26’ Carver Santa Cruz 1986
8’ Beam
260 Merc
5400# + gear
Displacement 5,000#
2 station steering

Adding a Merc Pro Kicker 15hp

I’d like to update the AP to run the kicker via EZ rod solo, while using the main to steer as well. (Uncle Norm’s Orca fin??)

I was told there was a conversion done previously and it no longer needed the res tank that should be mounted on the transom. Please forgive my ignorance, I’m used to a 14’ john boat for crappie fishing not trolling a Great Lake for salmon.

Old installed AP setup in attached pix.

Thanks in advance, Gam.
Find all posts by this user
Quote this message in a reply
02-27-19, 02:50 PM
Post: #2
RE: [CA11] AP Selection
Welcome to the Raymarine Forum Gamori,

As near as I can ascertain from the photo of the steering ram's cable, it appears to be a Teleflex 125-8EM (HC5328). The cubic capacity of this steering ram is 21.25 cu. in. (345 cc). This would typically require a Type 2 Hydraulic Pump. Should the currently installed hydraulic pump be operational, then it may be used with a T70162 EV-400 Power (included EV-1 CCU, ACU-400, p70RS control head, and Evolution Cabling Kit).
Find all posts by this user
Quote this message in a reply
02-28-19, 12:31 PM
Post: #3
RE: [CA11] AP Selection
Thank you, sir. -Gam
Find all posts by this user
Quote this message in a reply
02-28-19, 01:46 PM
Post: #4
RE: [CA11] AP Selection
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)