Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] How to change between TWS / AWS on Chart App Wind Vector
07-10-19, 08:15 PM (This post was last modified: 07-17-19 10:44 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] How to change between TWS / AWS on Chart App Wind Vector
Somewhere in a LH3.X upgrade I cannot seem to find how to toggle between TWS and AWS when I select the Wind vector from the Vessel Details pop over menu in LH 3.9. I can toggle between TWS and AWS on the I60 but the Axiom 9 seems to only display TWS vector. BTW, LH3.9 is really really good.
Thank You
Dan
Find all posts by this user
Quote this message in a reply
07-17-19, 10:44 AM
Post: #2
RE: [CA11] How to change between TWS / AWS on Chart App Wind Vector
Welcome to the Raymarine Forum Dan,

The wind vector displayed within the Chart application cannot be configured to display an apparent wind vector. The Wind Vector feature is intended to display True Wind.
Find all posts by this user
Quote this message in a reply
07-21-19, 07:03 PM
Post: #3
RE: [CA11] How to change between TWS / AWS on Chart App Wind Vector
Thanks Chuck.
After thinking about it while using the display with the Heading vector, COG vector and the tide vector, the TWS vector makes the most sense.
Dan
Find all posts by this user
Quote this message in a reply
07-22-19, 09:50 AM
Post: #4
RE: [CA11] How to change between TWS / AWS on Chart App Wind Vector
You're welcome.
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)