Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Failure i50 Tridata
10-02-19, 09:52 AM
Post: #21
RE: [DG11] Failure i50 Tridata
Hi svonset,

the three dashes indicate the display is not reading the transducer, assuming the transducer is connected to this display and all the connections are secure and the cable is not damaged, then it sounds like the transducer is faulty.

You have said the speed is being displayed correctly on the i70, do you have the speed and depth transducer connected to an itc-5 transducer box? if yes, then the i50 tridata should be set to repeater mode. if in repeater mode it still does not display data, then check the STng network, maybe a terminator is missing or there is some break in the backbone or spur cable or the connectors are not making good contact?
Regards
Derek
Find all posts by this user
Quote this message in a reply
10-03-19, 10:19 AM (This post was last modified: 10-03-19 10:58 AM by Chuck - Raymarine - Moderator.)
Post: #22
RE: [DG11] Failure i50 Tridata
Thanks Derek. Could be a bad cable after all. I’ll try to run a new one and/or redo the connection. Will keep you posted. Do you get to go to the Annapolis boat show?
Find all posts by this user
Quote this message in a reply
10-07-19, 10:59 AM
Post: #23
RE: [DG11] Failure i50 Tridata
Hi Svonset,

I will not be at Annapolis, Don't get to travel to the US from the UK!! However, my US colleagues will certainly be in attendance.
All the best
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)