Replace ST60 Tridata with i50 Tridata

[sailjumanji]

sailjumanji,

Q1/A1. I checked again, and realize I wrote the connection wrong before. The converter is powered, connected through a white plug. The i50 Tridata connects to the converter through a second white plug. The ST60+ Wind connects to a yellow plug on the converter. The autopilot has its own power, and therefore only the data wires are connected to the ST60+wind.

I do not know the version of software for the converter. My MFD is a B&G Zeus2. The converter was purchased new in mid 2015, and installed then. Is there a way to check the version of software for the converter, and/or update WITHOUT a Raymarine MFD?

Q2/A2. The depth and speed transducers are left over from the ST60 Tridata. They are both plugged into the i50 Tridata display. I don't know how to configure the i50 Tridata instrument as the "Depth master". Did not see that in the instructions. If that is required, could you please advise procedure?