The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / Repairable Rudder Reference Unit?

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Repairable Rudder Reference Unit?
05-09-17, 11:00 AM
Post: #1
utilityman Offline
Junior Member
**
 		Posts: 1
Joined: May 2017
Reputation: 0
Repairable Rudder Reference Unit?
My ST5000+ rudder bar stopped working in Standby mode. I can see it if I turn it on under Setup and when I put it in Auto, but it doesn't display under Standby.

I did the Rudder Reference Tests with a multi-meter and the Red to Green read 4.71 ohms and I'm not reading anything between the other wires, even when turning wheel hardover to hardover.

Is this repairable? Can I cut the wire close to the Rudder Reference Unit and test there to see if there's a break in the wires? If I take the bottom off the unit are there any tests than can be performed? Or does it need to be replaced?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Repairable Rudder Reference Unit? - utilityman - 05-09-17 11:00 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication