Almost Completed Axiom Network Question

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Tamarrow,

Q: When I press the Active Button on the RMS-10 again, the next chart pane on that MFD will become active. When I press the Active Button a third time, shouldn't a half chart pane on the other MFD (the one I paired second) become active? then, when I press the Active button again, shouldn't the next half chart pane on the second MFD becomes active and then, when I press it again, shouldn't it jump back to the first MFD chart pane, etc...? I have not been able to get that to happen?

A: When a RMK-9 or RMK-10 is paired to a set of MFDs, and the keypad's Active Pane button is pressed and released, the Select Active Application dialog should be displayed on one of the paired MFDs. Rotating the RMK-9 or RMK-10's UniController knob should then cause this dialog to alternately be displayed on one or the other MFD. When this dialog appears on the MFD which you would like to remotely control, then press the RMK-9's or RMK-10's OK button.

The initial release of Axiom MFD software was not intended to support pairing of multiple MFDs with an RMK-9 or RMK-10. It presently expected that the next release (currently expected to be release in late Q2 or early Q3 of 2017) of Axiom MFD software will support pairing of multiple MFDs with an RMK-9 or RMK-10.