Axiom/RV-100 installation

[Chuck - Raymarine - Moderator]

JPA,

Q 1. If the problem is within the B-60 and if I am viewing data from the RV-100 but numerical depth from the B-60, would a B-60 error cause the error message to show on an RV-100 data screen?
A 1. It is indeed possible that the message may be reported within any of the displayed Fishfinder panes.

Q 2. For several years the DS500x was stored below deck and the above deck cable connectors were not protected with dielectric grease. When I had the problem with the DS500x, I suspected that the issue was related to pin corrosion problems at the transducer or Power/Nema 0183 connector. If the B-60 connector pins are a bit corroded, would that be likely to cause the problem that I am seeing with the Axiom?
A 2. It is possible that this may be a cause for the reported problem. However, as the problem manifested itself only after an extended period of use, I believe that it is more likely resulting from insufficient power or another issue with the transducer.