The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Quantum to Axiom via WiFi - intermittent
08-13-17, 04:23 PM
Post: #1
Quantum to Axiom via WiFi - intermittent
I have just installed an Axiom 9" MFD (s/w v 3.1.96) at my Nav station in a GRP sail boat and a Quantum Radome low down on my mast, 4.8 meters straight line between them. Using WiFi, they are "paired" but the radar display is intermittent, i.e. the scan may run for a few cycles then the sweep stops momentarily and restarts further round the cycle. After a short time the scan stops and the "OFF/Not connected" screen appears on the display. Sometimes it will re-connect, other times is does not find the radar. The boat is out of the water, in a boat yard, with a number of other WiFi systems operating within range. The Axiom appears to use WiFi Ch1 and the boat yard powerful WiFi is on an adjacent Channel. Is there a problem with Axioms/Quantum and WiFi interference?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Quantum to Axiom via WiFi - intermittent - Ken19 - 08-13-17 04:23 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)