Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] ST6001 Calibration Issues

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] ST6001 Calibration Issues
11-28-17, 12:30 PM (This post was last modified: 05-24-19 07:39 AM by Chuck - Raymarine - Moderator.)
Post: #10
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] ST6001 Calibration Issues
Trent,

Q1. When I try to complete the Seatrial calibration, the control unit will not change from "Turn Boat". As suggested, I also tried running through the calibration with the gyro disconnected but ended with the same result. Even if I speed up and run in circles or a straight line it will not change from Turn Boat.
A1. When turning the boat to determine the deviation field sensed by the fluxgate compass, the rate of turn must be very slow. Should the rate of turn be too fast and there be no issue with the fluxgate compass or course computer, then the operator will be informed that the vessel's rate of turn is too fast. The fluxgate compass test is used to determine the operational state of the fluxgate compass.

Q2. Does the fact that the AP engages rule out a problem with the computer?
A2. No.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ST6001 Calibration Issues - tpburt - 11-16-17, 03:18 PM
RE: [CA11] ST6001 Calibration Issues - Chuck - Raymarine - Moderator - 11-28-17 12:30 PM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication