Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] ST6001 Calibration Issues

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] ST6001 Calibration Issues
12-01-17, 01:19 PM (This post was last modified: 05-24-19 07:40 AM by Chuck - Raymarine - Moderator.)
Post: #14
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] ST6001 Calibration Issues
Trent,

No additional buttons need be pressed after "Turn Boat" is displayed. However, should the fluxgate compass be binding, it would not be detected within the resistance testing portion of the Fluxgate Compass Test FAQ ... hence the reason for additionally monitoring the displayed compass heading when executing a slow turn to ensure that no large heading changes (jumps) are observed. The latter will also cause the autopilot to be sense too great a rate of turn and/or incomplete turn and prevent the calibration from being completed.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ST6001 Calibration Issues - tpburt - 11-16-17, 03:18 PM
RE: [CA11] ST6001 Calibration Issues - Chuck - Raymarine - Moderator - 12-01-17 01:19 PM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication