[CA] Axiom Water Temperature Selection

[SalishMermaid]

I have an Axiom 12 with a Airmar ST800 and RV-212 transducers connected. I believe the Temperature function on my ST800 is not working but I am using it for the Speed function. I had hoped to use the RV-212 for the temperature, but I can't find a way to select which transducer pull the temperature from.

When in the RV-212 setup screen it shows the temperature from the RV-212 and it is accurate. The only temperature that will display on the screen is the faulty 104degree temperature I assume from the ST800.

There is a info note on the RV-212 screen that says this is not the system temperature, but I can't figure out how to set it as the system temprature. There is a question mark on the screen, but I tried to click on it and nothing happens. I assumed that it would have opened with some instructions.

Is this something that is in work to be fixed on a later software update or am I just missing how to configure it to pull the temperature from the RV-212?