(DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

(DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone

04-30-18, 08:26 AM

Post: #6

Derek - Raymarine - Moderator Offline

Administrator

Posts: 1,416
Joined: Nov 2017
Reputation: 9

RE: (DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone

HI Art20c

Thank you for your response

The Kit is supplied with a cable that plugs into the yellow socket on the converter, the other end of the wire is bare cables - because most VHF radios will also have an NMEA cable with bare ends - you then simply connect the appropriate colours to each other using a connector block.

It really is the easiest least cost way of doing this.

The alternative is to run cables to the AIS 650, identify the NMEA 0183 4800 baud output and connect this tothe NMEA for the radio.

regards

« Next Oldest | Next Newest »

Messages In This Thread

(DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone - Art20c - 04-27-18, 01:50 AM

RE: (DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone - Derek - Raymarine - Moderator - 04-27-18, 03:59 AM

RE: (DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone - Art20c - 04-27-18, 09:12 AM

RE: (DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone - Derek - Raymarine - Moderator - 04-27-18, 11:04 AM

RE: (DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone - Art20c - 04-27-18, 02:30 PM

RE: (DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone - Derek - Raymarine - Moderator - 04-30-18 08:26 AM

RE: (DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone - Art20c - 04-30-18, 10:40 AM

RE: (DG) Connecting NMEA 0183 Version (1.5 to 2.3 ) to seatalking backbone - Derek - Raymarine - Moderator - 04-30-18, 11:01 AM

User(s) browsing this thread: 1 Guest(s)