[TG11] diagnosing issue with ST4000 wheel autopilot

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] diagnosing issue with ST4000 wheel autopilot

07-16-18, 12:59 PM (This post was last modified: 07-18-18 01:23 PM by Chuck - Raymarine - Moderator.)

Post: #1

laurentdubois Offline

Junior Member

Posts: 8
Joined: May 2018
Reputation: 0

[TG11] diagnosing issue with ST4000 wheel autopilot

Hello,

I'm looking for help with diagnosing the following problem with my ST4000 wheel autopilot.
After working properly in auto mode for a certain period of time with no issue (about an hour or so), the autopilot will start turning hard to the starboard side and go in a circle.
Then going to standby mode, the autopilot will continue acting weird and display 4001 (is that an error code?).
I verified that nobody placed any metal near the compass when the problem occurred the first time.
This has happened 3 times since, and cannot use the autopilot reliably anymore.

Thanks

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] diagnosing issue with ST4000 wheel autopilot - laurentdubois - 07-16-18 12:59 PM

RE: [TG11] diagnosing issue with ST4000 wheel autopilot - Tom - Raymarine - Moderator - 07-18-18, 01:48 AM

RE: [TG11] diagnosing issue with ST4000 wheel autopilot - laurentdubois - 07-18-18, 08:09 AM

RE: [TG11] diagnosing issue with ST4000 wheel autopilot - Tom - Raymarine - Moderator - 07-19-18, 01:48 AM

RE: [TG11] diagnosing issue with ST4000 wheel autopilot - laurentdubois - 07-19-18, 09:10 AM

RE: [TG11] diagnosing issue with ST4000 wheel autopilot - Tom - Raymarine - Moderator - 07-19-18, 06:27 PM

User(s) browsing this thread: 1 Guest(s)