[DG] [DG] ST60 Wind Speed Calibration

[Derek - Raymarine - Moderator]

Hi Drew
Thank you for your enquiry.

The ST60 displays had the speed calibration capability, you need to access the Dealer Calibration as follows

Press DISP and TRUE/APP buttons exactly together and hold them down for 12 seconds until the display changes to DLR
As soon as DLR appears, release these two buttons and immediately 'stab' or momentarily press the VMG and TACK buttons exactly together, the display will change to UC1

Press the DISP button 4 times until the current wind speed is shown.
Press VMG and TACK buttons momentarily to select the Speed calibration factor and then adjust it with either the VMG or the TACK button
once value is corrected, press and hold the DISP and TRUE/APP buttons exactly together for 2 seconds to exit calibration and store.

this is also covered in Section 4.4 Dealer Calibration of the handbook

regards
Derek