The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [TG] [TG11] e95 MFD won't boot

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] e95 MFD won't boot
09-26-18, 07:35 PM (This post was last modified: 09-28-18 08:09 AM by Chuck - Raymarine - Moderator.)
Post: #1
JohnRE Offline
Junior Member
**
 		Posts: 8
Joined: Feb 2018
Reputation: 0
[TG11] e95 MFD won't boot
I installed an e95 MFD along with an EV-100, and i70 and i50 instruments this spring. I updated all the software during the installation. All have worked well, until recently when the e95 started to be very slow to boot up. Now I can’t get it to boot. I have not changed or added anything on the network.

There’s a weak beep when I press the e95 power button, but the display does not change. I’ve tried cycling the power at the circuit breaker to no effect. I measured the voltage to the e95 at the terminal block inside my NavPod at 12.9 Volts.

Should I send the e95 in for repair?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] e95 MFD won't boot - JohnRE - 09-26-18 07:35 PM
RE: [TG11] e95 MFD won't boot - JohnRE - 10-01-18, 06:57 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication