The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Type 1 pump installation

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Type 1 pump installation
01-10-19, 08:33 PM (This post was last modified: 01-11-19 09:59 AM by Chuck - Raymarine - Moderator.)
Post: #1
captainjj Offline
Junior Member
**
 		Posts: 1
Joined: Feb 2016
Reputation: 0
[CA11] Type 1 pump installation
I need to replace the wheel drive on my ST4000. The old unit could no react quickly enough with my existing hydraulic steering. Would replacement with Type 1 hydraulic pump be a possible fix, system is 5 turns lock to lock. The boat is full keel with a barn door rudder, 43ft 15 tons.
The steering has the pump and reservoir at the helm but with only two lines leading out to a manifold which supplies the two steering rams. Could the reservoir inlet at the pump be ignored?
Thanks for any insight, James
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Type 1 pump installation - captainjj - 01-10-19 08:33 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication