[CA] [CA11] ST70/Smart Pilot x30

[dapagani]

Chuck,
again, thank you for your help and guidance, wanted to follow up as to the solution. I checked all the cables, checked the terminators, everything was fine, then I removed the additional "T" connector, and power line to the ST ng, when I went to flip the switch for power from the CCU as I removed the ST ng power feed, I noticed the ST right angle connector on the CCU was loose, not making good connection, once I seated that, all worked well. I will look at adding a zip tie to hold the connector in place.
Going forward, will also investigate an interface to the garmin mfd. I did notice a cable on the RM web to go from ST ng to N2K, cable pn # is A06046 / 59.1in (1.5m) DeviceNet Male, says it will Adapts SeaTalkng to NMEA2000 network. Available with Male or Female ends.

will this not connect my AP to N2K?