[CA] [CA11] Networking seatalk to seatalkng

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Jschanter,

Please click here to view a FAQ addressing this subject. As the Type 100 autopilot course computer's design pre-dates the Type 150/400 autopilot course computer, it may not be interfaced to the system via a SeaTalk to SeaTalkng Converter. Instead, it would be recommended that
- the ST7000 and Type 1 autopilot course computer be disconnected from the SeaTalk bus, leaving only the ST60 instrument to be interfaced to the ST-STng Converter
- the NMEA 0183 Port 1 Output of one of the e97 MFDs be interfaced to the NMEA 0183 input port of either the ST7000 or the Type 100 autopilot course computer

The diagram be modified to show that the e97 MFDs will be interfaced to one another via an appropriate length of RayNet (F) to RayNet (F) Cable.

The diagram also incorrectly show that e97 MFDs have been interfaced to the backbone sockets of the SeaTalk to SeaTalkng Converter. Instead, you will need to add two additional spur (white) sockets to the backbone created by the SeaTalk to SeaTalkng Converter. The MFD's in turn would be interfaced to these spur socket via and appropriate length of SeaTalkng Spur Cable. SeaTalkng Termination Plugs will be installed within the backbone's two unoccupied backbone (blue) sockets.