[CA11] Proper power config for E22158

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Proper power config for E22158

02-07-19, 11:11 AM

Post: #6

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: [CA11] Proper power config for E22158

amajamar,

Q. My diagram shows power to both the NMEA 2000 backbone AND the E22158. Which configuration is correct?
A. Apparently I did not see that your existing NMEA 2000 backbone was powered. A system's SeaTalkng / NMEA 2000 backbone should be powered from a single power insertion spur which is located at the approximate midpoint of the backbone's LEN load.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Proper power config for E22158 - amajamar - 02-06-19, 02:54 PM

RE: [CA11] Proper power config for E22158 - Chuck - Raymarine - Moderator - 02-06-19, 03:41 PM

RE: [CA11] Proper power config for E22158 - amajamar - 02-06-19, 04:59 PM

RE: [CA11] Proper power config for E22158 - Chuck - Raymarine - Moderator - 02-06-19, 05:14 PM

RE: [CA11] Proper power config for E22158 - amajamar - 02-11-19, 12:47 PM

RE: [CA11] Proper power config for E22158 - amajamar - 02-07-19, 09:41 AM

RE: [CA11] Proper power config for E22158 - Chuck - Raymarine - Moderator - 02-07-19 11:11 AM

RE: [CA11] Proper power config for E22158 - Chuck - Raymarine - Moderator - 02-11-19, 01:35 PM

User(s) browsing this thread: 1 Guest(s)