Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] replacing C80 with two E80's Seatalk connection

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] replacing C80 with two E80's Seatalk connection
02-13-19, 11:46 AM (This post was last modified: 02-13-19 12:09 PM by Chuck - Raymarine - Moderator.)
Post: #7
andyschoenb Offline
Junior Member
**
 		Posts: 14
Joined: Apr 2018
Reputation: 0
RE: [CA11] replacing C80 with two E80's Seatalk connection
Thank you Chuck for that last response - I have one last question.
Because I must change the NavPod from the shallow depth one on the C80 to a deeper one for the E80 I am stuck with a dilemma. It is not possible to get the Radar plug through the [censored] in the NavPod.
I can either cut the [censored] in the NavPod bigger and risk water intrusion, or cut the radar cable and use a junction block for re-connection. Is there an issue with cutting the radar cable (number and size of wires) and using a junction block for reconnecting??? Will this negatively affect the performance of the radar??
Thank you for your support
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] replacing C80 with two E80's Seatalk connection - andyschoenb - 02-13-19 11:46 AM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication