[DG] [DG11] New X-5 Wheel Pilot showing Error "No Pilot"

[Oday32CC]

Thank you for your fast response Derek, I really appreciate that.

1) You mentioned that "STng connection to the SPX5 computer shows the screen/ shield not connected". I did connect it now, however the manual highlights to not connect the screen / shield and yellow cable. This said, connecting it didn't change anything. The same error is still displayed.

2) I also exchanged the power cables to some bigger ones. Unfortunately this didn't resolve the error either.
2a) checking the voltage at the power connection I surely have 13.5V. This
said, I also checked the power on both fuses and realized that the
SeaTalk fuse is only getting very little voltage <1V - is this normal?

3) The connections and configuration of the backbone: I only have the autopilot installed and therefore connected everything directly to the computer, as outlined in the manual. Is this creating any problems?

4) When working on it today I realized some orange/green blinking LEDs on the computer. Here a video: https://youtu.be/2TZnBK99sLE - I couldn't find any information on what does might mean, maybe you can help here?

Setting this system up doesn't seem too hard, but somehow I must be doing something wrong...

Than you again,
Sascha