Raymarine forum / Raymarine Forums / Multifunction Displays v / [TG] [TG11] Sounder Supply Voltage Too Low

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Sounder Supply Voltage Too Low
05-10-19, 10:17 PM (This post was last modified: 05-23-19 12:49 PM by Chuck - Raymarine - Moderator.)
Post: #5
ddfour1 Offline
Zamboati
***
 		Posts: 66
Joined: Feb 2016
Reputation: 0
RE: [TG11] Sounder Supply Voltage Too Low
Tom,

I checked my voltage and connections to the port Axiom and I don't think there are any issues. I cut and re-spaded the ground to be sure. I measured voltage while plugged in and it was 14.4v at the terminals. The Axiom display (in the product information screen) also shows 14.4 volts when I am plugged into shore power and even at that time the low voltage error was observed on the port fishfinder screen. Both of my other two Axiom's display the fishfinder data no problem.

I did a factory re-set--no joy.

Dave
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG11] Sounder Supply Voltage Too Low - ddfour1 - 05-10-19 10:17 PM

Forum Jump:


User(s) browsing this thread: 4 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication