[CA11] S2G and ST7001 no autolearn

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] S2G and ST7001 no autolearn

07-16-19, 02:37 PM (This post was last modified: 07-22-19 12:52 PM by Chuck - Raymarine - Moderator.)

Post: #1

PHINNROS Offline

Older Sailor and Builder

Posts: 11
Joined: Feb 2019
Reputation: 0

[CA11] S2G and ST7001 no autolearn

I installed my S2G course computer and the ST7001 control head. I have run the basic calibrations and sea trails and it all basically works. However when I run the seatrial Autolearn does not come up in the menu. Am I missing something? Can it be Pinned out on the board? The S2G was purchased used.

I now I can make all of the manual adjustments but it would be good to have the auto learn function.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] S2G and ST7001 no autolearn - PHINNROS - 07-16-19 02:37 PM

RE: [CA11] S2G and ST7001 no autolearn - Chuck - Raymarine - Moderator - 07-22-19, 01:06 PM

RE: [CA11] S2G and ST7001 no autolearn - PHINNROS - 07-23-19, 10:46 AM

RE: [CA11] S2G and ST7001 no autolearn - Chuck - Raymarine - Moderator - 07-23-19, 10:52 AM

RE: [CA11] S2G and ST7001 no autolearn - PHINNROS - 07-23-19, 01:40 PM

RE: [CA11] S2G and ST7001 no autolearn - Chuck - Raymarine - Moderator - 07-23-19, 01:43 PM

RE: [CA11] S2G and ST7001 no autolearn - PHINNROS - 07-26-19, 04:22 PM

RE: [CA11] S2G and ST7001 no autolearn - Chuck - Raymarine - Moderator - 07-29-19, 08:18 AM

User(s) browsing this thread: 1 Guest(s)