The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [TG] [TG11] Upgrade E Series Classic Slave

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] Upgrade E Series Classic Slave
08-22-19, 02:02 AM (This post was last modified: 08-23-19 10:07 AM by Chuck - Raymarine - Moderator.)
Post: #1
Caverneer Offline
Junior Member
**
 		Posts: 3
Joined: Aug 2019
Reputation: 0
[TG11] Upgrade E Series Classic Slave
I have an E120 with an E80 slave at the helm. GPS, compass, radar etc. go to the E120. The card reader on the E120 is broken, so the chart card is in the E80. I have had no problems with the system, but wanted to upgrade from V2.30 to V5.69 as I have installed a Raymarine AIS700 transponder.

I upgraded the E80 (as only its card reader works), but when I tried to upgrade the E120 (using Ethernet option) I got a message that the E80 could not communicate with the E120.

Now, as the two units have different software, the chart does not show on the E120. (This effect is mentioned on some other thread.)

What should I do? Roll back the update and upgrade the slave first? If so, how?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] Upgrade E Series Classic Slave - Caverneer - 08-22-19 02:02 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication