Threaded Mode | Linear Mode

ray18

Hi,

I finally got it to work using Yamaha gateway 6YG as you suggested. Thanks.
My 2019 digital Yamaha 70 hp 4 stroke has only 16.6 hours so I am going to have to use it more before winter gets here.
Yes, there are 2 BUS ports on the Yamaha Command Link Hub but I only needed 1 terminator cap to complete the circuit.

No other device needed.

I do have an issue when trying to open the Yamaha app in my Raymarine Axiom 9" MFD when first start-up the entire system. It kept saying "this is NOT supported by this display"??? and the engine data have a delay about 20 seconds before it will show up.

I found out if I touch "Settings" - boat details - identify engine - click yamaha and exit out of settings and click Yamaha app then it would work. But, if I left the settings in other engines then it would say "this is not supported by this display" when I tried to open the Yamaha app.

Unsure if this setting solution is a co-incidence or a true solution??? I will test more and report back.

The trim tab will first start to flash in yellow/gold, and after 20 seconds I will get battery voltage. and at that point everything else RPM, engine hours etc. will display.
Would dashboard app work without Yamaha app for my Yamaha 70 hp?