The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Networking / System Integration v / [CA] [CA11] SmartController not connecting to the SeaTalkng network

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] SmartController not connecting to the SeaTalkng network
10-18-19, 04:21 PM (This post was last modified: 10-21-19 02:06 PM by Chuck - Raymarine - Moderator.)
Post: #1
Pawseidon Offline
Junior Member
**
 		Posts: 10
Joined: Jul 2019
Reputation: 0
[CA11] SmartController not connecting to the SeaTalkng network
I'm just finishing a new installation that was to include a SmartController. I purchased a cable (A06047) in order to connect the base station to a port on a SeaTalkng 5 way connector via a D244 ST1 junction block. The SmartController registers and connects to the base station with a strong signal but the base is not transmitting any data and the SmartController displays "No Pilot".
I connected the SmartController directly to the ST1 end of the A06047 cable and it still did not display any information. The other two devices that are connected to the SeaTalkng 5 way connector are working properly. Also, my Axiom MDF's do not identify this base station as a device on the network. Could this be a bad cable? Something else? Thanks.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] SmartController not connecting to the SeaTalkng network - Pawseidon - 10-18-19 04:21 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication