[TG11] autopilot active when set from control not from MFD.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] autopilot active when set from control not from MFD.

10-29-19, 12:34 AM

Post: #4

Tom - Raymarine - Moderator Offline

Administrator

Posts: 1,067
Joined: Nov 2017
Reputation: 7

RE: [TG11] autopilot active when set from control not from MFD.

Hello Chris,

Did you have any luck with the pilot error message?

Re. the helm activity, there are various possible causes and resolutions to that, depending on your pilot Course Computer (the systems are modular and various CCs could be controlled by an ST6001+ display) and drive unit. It might be that you have a bit of play and 'flywheel' effect in your system, or your Rudder Gain is a bit high or low for example. If you can take a little video of the behaviour and post it back here, and let me know what drive unit type and course computer model you have, I can give you some more specific info.

Thanks,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] autopilot active when set from control not from MFD. - Skipperc - 07-16-19, 10:17 PM

RE: [TG11] autopilot active when set from control not from MFD. - Tom - Raymarine - Moderator - 07-24-19, 02:44 AM

RE: [TG11] autopilot active when set from control not from MFD. - Skipperc - 10-20-19, 10:46 PM

RE: [TG11] autopilot active when set from control not from MFD. - Tom - Raymarine - Moderator - 10-29-19 12:34 AM

User(s) browsing this thread: 1 Guest(s)