[CA11] Replacing M232 with a M625

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Replacing M232 with a M625

01-28-20, 06:23 AM (This post was last modified: 01-28-20 01:03 PM by Chuck - Raymarine - Moderator.)

Post: #1

Mig888 Offline

Junior Member

Posts: 18
Joined: Sep 2019
Reputation: 0

[CA11] Replacing M232 with a M625

I recently bought a M232 camera to put in a new boat that is in construction. I am reading that the M625 performs better even though it lacks pan and tilt. If I decide to replace the M232 with the M625, does a new cable have to be run or can it operate off the same cable as the M232. I did not install the camera so I am assuming that the cable is not permanently connected to the camera and is a plug in. Also, would it fit into the same mount?

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Replacing M232 with a M625 - Mig888 - 01-28-20 06:23 AM

RE: [CA11] Replacing M232 with a M625 - Chuck - Raymarine - Moderator - 01-28-20, 01:53 PM

RE: [CA11] Replacing M232 with a M625 - Mig888 - 01-28-20, 06:05 PM

RE: [CA11] Replacing M232 with a M625 - Chuck - Raymarine - Moderator - 01-29-20, 09:33 AM

User(s) browsing this thread: 1 Guest(s)