The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] C90W not showing detail

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] C90W not showing detail
02-28-20, 03:27 PM (This post was last modified: 02-28-20 03:35 PM by Chuck - Raymarine - Moderator.)
Post: #1
Rangerman Offline
Junior Member
**
 		Posts: 1
Joined: Feb 2020
Reputation: 0
[CA11] C90W not showing detail
Hi all
I have two C90W’s with pre-installed charts, one in the cabin and the other on the fly bridge. The cabin unit is set as the master but when used without the fly unit switched on shows considerably less detail no contours or additional wrecks. However when both units are on all contours, wrecks and detail are shown. I have done a reset on the cabin unit with no change. Software on both units is v2.35
Settings
Safety contours = 66ft
Depth contour = All
Additional wrecks = on

Any suggestions pls
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] C90W not showing detail - Rangerman - 02-28-20 03:27 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication