The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] S100 Range is inches not 30'

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] S100 Range is inches not 30'
03-19-20, 04:02 PM (This post was last modified: 03-20-20 08:41 AM by Chuck - Raymarine - Moderator.)
Post: #1
kev_rm Offline
Junior Member
**
 		Posts: 3
Joined: Oct 2019
Reputation: 0
[CA11] S100 Range is inches not 30'
Newly purchased S100, running an EV400 thru a ST1-STNG converter. The converter works fine, all data is available on ST1 and STNG, it was pre-existing. The remote pairs with the transceiver and will operate the pilot, but only if it is within inches of the transceiver.

Batteries for remote, tried two sets, at 3.1V
Voltage on +/- pins on transceiver 12.6V

I could make no sense of the instructions about the power cable. Does the transceiver need a dedicated circuit instead of power from ST1?

Network diagram attached.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] S100 Range is inches not 30' - kev_rm - 03-19-20 04:02 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication