[CA11] Linear rudder reference transducer setup

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Linear rudder reference transducer setup

03-27-20, 04:30 PM (This post was last modified: 03-27-20 05:45 PM by Chuck - Raymarine - Moderator.)

Post: #7

bellinghamangler Offline

Junior Member

Posts: 4
Joined: Apr 2019
Reputation: 0

RE: [CA11] Linear rudder reference transducer setup

Ok, that all worked and I was able to reverse the rudder. the rudder indicator bars on the control did indeed move in the correct direction. I then went to complete the dockside wizard and after the manual turning of the rudder from port to starboard, I was presented with a Values Too Close error.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Linear rudder reference transducer setup - bellinghamangler - 03-04-20, 06:01 AM

RE: [CA11] Linear rudder reference transducer setup - Chuck - Raymarine - Moderator - 03-04-20, 03:41 PM

RE: [CA11] Linear rudder reference transducer setup - bellinghamangler - 03-18-20, 09:25 AM

RE: [CA11] Linear rudder reference transducer setup - Chuck - Raymarine - Moderator - 03-18-20, 02:52 PM

RE: [CA11] Linear rudder reference transducer setup - bellinghamangler - 03-27-20, 03:02 PM

RE: [CA11] Linear rudder reference transducer setup - Chuck - Raymarine - Moderator - 03-27-20, 03:38 PM

RE: [CA11] Linear rudder reference transducer setup - bellinghamangler - 03-27-20 04:30 PM

RE: [CA11] Linear rudder reference transducer setup - Chuck - Raymarine - Moderator - 03-27-20, 05:41 PM

User(s) browsing this thread: 1 Guest(s)