[CA] [CA11] New Axiom Install

[TJ Champion]

Chris,
Thank you for getting back to me.
I don't quite understand the answer to Question #1. The converter had a molded Seatalk connector that daisy-chained through the ST701+ to the ST60 instruments. do I cut off the molded ends and splice the wires together?
Also, Chuck instructed me to set up a second bus as follows:

"A1. Negative. I am suggesting that you will need to create two SeaTalk busses, one for the control head and remote. The other will be for the instruments and connection to the ST-ST1 Converter.
----- SeaTalk bus 1: ST7001<->ST600R<->Course Computer ST Port #1 (connect all leads of SeaTalk cable to course computer)
----- SeaTalk bus 2: ST-STng Converter<->ST60<->ST60<->ST60<->Course Computer ST Port #2 (connect only yellow and shield leads of SeaTalk cable to course computer)"
This apparently kept the NG system for being feed from two sources
I'm not sure how to handle it since the new course computer seems to have only one buss.