[TG11] Edson Rudder Arm - Linear drive mounting location

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] Edson Rudder Arm - Linear drive mounting location

05-27-20, 09:45 AM (This post was last modified: 06-01-20 11:28 PM by Tom - Raymarine - Moderator.)

Post: #1

clburti Offline

Junior Member

Posts: 11
Joined: Mar 2016
Reputation: 0

[TG11] Edson Rudder Arm - Linear drive mounting location

I am upgrading our EV-100 Raymarine Wheel Pilot installed in a Catalina 320 to an ACU-200 and Type 1 Linear Drive. Edson advised me to check with Raymarine on how far from center of rudder shaft to drill the rudder arm for the tiller pin.

Thanks,
CB

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] Edson Rudder Arm - Linear drive mounting location - clburti - 05-27-20 09:45 AM

RE: [TG11] Edson Rudder Arm - Linear drive mounting location - Tom - Raymarine - Moderator - 06-01-20, 11:29 PM

RE: [TG11] Edson Rudder Arm - Linear drive mounting location - clburti - 06-03-20, 07:37 AM

RE: [TG11] Edson Rudder Arm - Linear drive mounting location - Tom - Raymarine - Moderator - 06-05-20, 12:15 AM

User(s) browsing this thread: 1 Guest(s)