The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [TG] [TG11] ST2000 to Lowrance Elite 5 connection

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] [TG11] ST2000 to Lowrance Elite 5 connection
05-28-20, 06:17 AM (This post was last modified: 06-05-20 12:35 AM by Tom - Raymarine - Moderator.)
Post: #1
JFD Offline
Junior Member
**
 		Posts: 1
Joined: May 2020
Reputation: 0
[TG11] ST2000 to Lowrance Elite 5 connection
The ST2000 is not talking to my chartplotter. I connected my new ST2000 to my Elite 5 chartplotter and when I try to have the ST2000 go to the waypoint on my chartplotter I just get an error message. I know the chartplotter is sending information to the ST2000 because I am able to measure low voltage pulses (around 1 volt) then 0 then 1v at the connection. A fellow sailer has the same setup and his is working. However he is many hours away. We have talked and I know the wiring connections are correct. The chartplotter has a connection dedicated to speed/temp or NMEA0183 and I have set it to NMEA output.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[TG11] ST2000 to Lowrance Elite 5 connection - JFD - 05-28-20 06:17 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication