[CA11] E28081 Wind Transducer Service Kit Instructions

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] E28081 Wind Transducer Service Kit Instructions

07-08-16, 02:31 PM (This post was last modified: 06-04-18 09:26 AM by Chuck - Raymarine - Moderator.)

Post: #2

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: E28081 Wind Transducer Service Kit Instructions

Welcome to the Raymarine Forum Brian,

There's no magic to replacing the vane and cups included within the A28167 Raymarine Masthead Wind Transducer Service Kit (for masthead wind transducers designed for use with the iTC-5, i60 Wind, ST290 Wind Pod, and ST60/ST60+ Wind). These assemblies are each secured to their respective shafts with a set screw. Removal of the currently installed vane and cup assembly is simply a matter of loosening the set screws and then removing the vane and cup assemblies from their shafts. The replacement part vane and cup assemblies will then be positioned on the shafts and the set screws within these items will then be tightened. It is recommended that wind transducers be calibrated following any servicing or replacement of the transducer.