Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Placement of tiler pilot arm EV-100
11-01-16, 02:59 PM (This post was last modified: 11-01-16 03:00 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Placement of tiler pilot arm EV-100
Welcome to the Raymarine Forum Baraka,

Please note that the drive mechanism of the EV-100 Tiller is a worm gear drive rather than a hydraulic piston. The geometry and dimensions specified for the drive's installation are critical to permit the drive to perform properly and to additionally not be subjected to excessive load. The marked up .jpeg file which you have mentioned may be helpful in clarifying whether this drive is suited for the sailing vessel. It is recommended that the size of the .jpg file be reduced to less than 500kb and then attached as response to this post.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Placement of tiler pilot arm EV-100 - Chuck - Raymarine - Moderator - 11-01-16 02:59 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)