SeaTalk to SeaTalkng converter setup

[Chuck - Raymarine - Moderator]

Petr,

It is indeed possible to connect the second SeaTalk to SeaTalkng Converter to the T-Piece that is presently linking the MFD to the backbone ... simply remove the blue Termination Plug from the T-Piece, insert it into one of the blue backbone sockets of the second SeaTalk to SeaTalkng Converter, and then join the unoccupied blue backbone socket of the T-Piece to the remaining blue backbone socket of the second SeaTalk to SeaTalkng Converter via an appropriate length of SeaTalk to SeaTalkng backbone cable. Also, swap the SeaTalkng Power Cable's position within the first SeaTalk to SeaTalkng Converter to the spur socket which is presently linking the AIS650 to the SeaTalk to SeaTalkng Converter. The AIS650's spur cable may then be plugged into the socket which had been previously occupied by the SeaTalkng Power Cable. Doing so will more closely permit the backbone's power insertion point to be located at the approximate midpoint of the backbone's LEN load.