Raymarine forum / Raymarine Forums / Multifunction Displays v / [CA] [CA11] Updating EV-1, ACU-200, P70 Software

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Updating EV-1, ACU-200, P70 Software
11-27-19, 11:44 AM
Post: #4
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] Updating EV-1, ACU-200, P70 Software
Denis+Ellis,

The SeaTalkng power switch features two LEDs. When the switch is moved to the OFF position, the green LED to the left of the switch will be illuminated. When the switch is moved to the ON position, the red LED to the right of the switch will be illuminated. Within systems featuring more than a MFD and an Evolution autopilot within the backbone, it is recommended that the backbone be powered according to the best practice indicated within my last response to prevent under-powering the backbone. If the other devices meant to be powered by the backbone appear to be powered and the Status LED of the EV-1 not be illuminated, then there is either a fault with the EV-1 or the networking components connecting it to the backbone.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Updating EV-1, ACU-200, P70 Software - Chuck - Raymarine - Moderator - 11-27-19 11:44 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication